Saw Chain Filing And File Gauges - Husqvarna 365 SPECIAL Operator's Manual

Recommended cutting equipment for Canada
The following cutting attachments are approved for the models Husqvarna 365 SPECIAL, 372 XP and 372 XPG.
The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws and
Z62.3-04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Length,
Pitch, inch
inch
15
16
18
3/8
20
24
28
0,050"/1,3 mm H46
0,058"/1,5 mm H42
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries
!
to the user. Do not operate this saw unless you have extraordinary cutting needs and experience
and specialized training for dealing with kickback. Saws with significantly reduced kickback
potential are available. Always use the safest saw and cutting equipment applicable to your cutting
need.
Saw chain filing and file gauges
38 – English
TECHNICAL DATA
Guide bar
Gauge, Max. nose
inch radius
0,058 11T
H47
H48
Saw chain
Type
Husqvarna H42, Husqvarna H48
Drive link
count
56
60
68
72
84
93