Pride BAJA BANDIT Owner's Manual page 7

Battery Condition Meter
When the key is fully inserted into the key switch and turned clockwise to power up your vehicle, this meter
indicates approximate battery strength. For further information on the battery condition meter, see III. "Batteries and
Charging."
Speed Adjustment Dial
This dial allows you to preselect and limit your vehicle's top speed.
 The image of the tortoise represents the slowest speed setting.
 The image of the hare represents the fastest speed setting.
Turn Signal Buttons
 Press the appropriate turn signal button once to activate it. The turn signal will fl ash on the LCD screen.
 Press the same signal button to turn it off .
Throttle Control Lever
This lever allows you to control the forward speed and the reverse speed of your vehicle up to the maximum speed
you preset with the speed adjustment dial.
NOTE: The throttle control lever operation instructions outlined below apply to vehicles in a standard
confi guration. If the programming of your vehicle was modifi ed in any way by a Provider, contact that Provider
for correct throttle control level operation instructions.
To use throttle control lever:
 To move Forward, use your right hand fi ngers to pull back on the throttle control lever.
 To move Rearward, use your right hand fi ngers to push forward on the throttle control lever.
Release the throttle control lever and allow your vehicle to come to a complete stop before engaging the other side
of the lever. When the throttle control lever is completely released, it automatically returns to the center "stop"
position and engages your vehicle's brakes.
Handbrake Lever
Your vehicle is equipped with a handbrake lever which is located on the tiller handle. See fi gure 1. This lever
provides you with additional stopping power. The handbrake is manual and operates independently of your
vehicle's regenerative braking system which is engaged during operation of the vehicle by releasing the throttle
control lever.
To operate the handbrake lever:
1. Release the throttle control lever fully.
2. Gently squeeze the handbrake lever to bring your vehicle
to a complete stop.
NOTE: You must release the throttle control lever before
squeezing the handbrake lever. Otherwise, your vehicle
may not come to a complete stop.
NOTE: The handbrake lever may require periodic
adjustment to maintain proper operation. Adjustment
should only be performed by your authorized Pride provider
or other qualifi ed technician. Contact your authorized
provider for more information.
®
Mobility BA140
BAJA
I I . Y O U R V E H I C L E
IDENTIFICATION KEY
1. HANDBRAKE LEVER
2. SETSCREW
Figure 2. Handbrake Lever
7