Clock And Date: Setting; Underbody: Inspecting For Damage To Underbody Sealant, Underbody Panels, Routing Of; Lines, Plugs; Warning Stickers, Passat Gte: Checking - Volkswagen Passat 2015 Manual

Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
Maintenance - Edition 11.2020
– To rectify dents, slide bellows upwards, reach inside the
bellows with your hand and press out the dents.
– Check that bellows are properly engaged in axial bearing:
♦ Correct position: bellows can be turned around rotational
axis while seated in axial bearing.
♦ Otherwise pull bellows all-round out of axial bearing by one
notch.
♦ After that, the bellows should be able to be turned around
rotational axis.
4.65

Clock and date: setting

Setting time and date in Infotainment system
– Switch on ignition.
– Switch on Infotainment system.
– Press Infotainment button
– Press function button.
Setup
– Press
Time and date
– Select function button
– Select function button
4.66 Underbody: inspecting for damage to
underbody sealant, underbody panels,
routing of lines, plugs
NOTICE
• During inspection, also check floor pan, wheel housings
and sills.
♦ Always ensure that all lines are secured in their mountings,
that all plugs are available and that there is no visible
damage on the underbody.
♦ Faults found must always be rectified (repair measure).
This inhibits corrosion and rusting through.
4.67 Warning stickers, Passat GTE: check‐
ing
There are warning stickers on all high-voltage components.
When performing maintenance work, make sure that these
warning stickers are not soiled or damaged and are present
on all high-voltage components.
190
4. Descriptions of work
.
CAR
function button.
and set current time.
Time
set current date.
Date