Motor Compartment Cover (Noise Insulation) "Bottom": Removing And Installing; Engine Oil Level: Checking - Volkswagen Passat 2015 Manual

Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
Maintenance - Edition 11.2020
Installing
– To prevent damage, do not strike engine cover panel with
the fist or a tool.
– Position engine cover panel, paying attention to oil filler neck
and dipstick.
– Press engine cover panel into rubber grommets first on the
left side and then on the right side as seen facing direction of
travel.
4.37 Motor compartment cover (noise insu‐
lation) "bottom": removing and instal‐
ling
Sequence of operations
The procedure of removing the engine cover panel -bottom-
(noise insulation) can be found in Workshop Manual under:
⇒ General body repairs, exterior; Rep. gr. 66; Noise insulation;
Assembly overview - noise insulation.
4.38

Engine oil level: checking

Note the following:
– After shutting off engine, wait at least 3 minutes so that the
oil can flow back into the sump.
– Pull out dipstick, wipe with a clean cloth and push dipstick in
again to limit stop.
– Pull dipstick out again and read oil level.
Note
The oil level must always be in the upper third of area -B-
♦
for the delivery inspection. This way, you will achieve the
greatest possible customer satisfaction.
The oil-change quantity in the service table was determined
♦
experimentally and is sufficient for the technical functionality
of the engine in all operating conditions. During all other
service events, the oil level must be checked and corrected
as necessary if the customer requests this. This enables
an additional topping-up to the specified oil quantity to the
upper limit of the dip stick. Due to tolerances, the oil temper‐
ature and the drip time, various quantities may be required
for topping up.
A - Do not top up oil.
116
4. Descriptions of work