Operation; Before Use; Connecting; Disconnect - ULTIMATE SPEED 346098 2004 Instructions Manual

Operation

Before use

♦ Before connecting the charger, the operating
instructions must be observed .
♦ Furthermore, the instructions of the vehicle
manufacturer regarding a permanently
connected vehicle battery must be observed .
Secure the vehicle, switch off the ignition .
♦ Clean the battery poles . Take care that while
doing so, your eyes do not come into contact
with the dirt .
♦ Ensure sufficient ventilation .

Connecting

NOTE
► There are two options for connecting the
charger . Connect the negative terminal
connecting cable (black) either directly to
the negative terminal of the battery or to
the bodywork . Please also bear in mind the
vehicle manufacturer's instructions .
♦ Before starting the charging or trickle charging
procedure on a permanently installed battery in
a vehicle, first disconnect the negative terminal
connecting cable (black) of the vehicle from the
negative terminal of the battery . The negative
terminal of the battery is usually connected to
the vehicle's coachwork .
♦ Connect the positive pole clamp (red)
charger to the positive pole of the battery .
♦ Connect the negative pole clamp (black)
to the negative pole of the battery or to the
bodywork .
♦ Connect the mains cable
the mains socket .
♦ The battery voltage display
current battery voltage .
♦ Should the connection of the clamps be
swapped, the LED „reverse connection"
lights up .
ULGD 5.0 A1
of the
of the charger to
shows the

Disconnect

♦ Disconnect the appliance from the mains
supply .
♦ Remove the negative pole clamp (black)
from the negative pole of the battery or from the
bodywork .
♦ Remove the positive pole clamp (red)
the positive pole of the battery .
Measuring STANDBY/Battery
voltage
After connection to the grid, the appliance is on
STANDBY . The standby display
the clamps are connected, the battery voltage
is shown in the LCD (voltage display
segments of the condition display
If the voltage is below 3.8 V or above 15 V, the
battery will not be charged. The display briefly
shows the error message „Err".
The appliance goes on standby.
6 V battery
If the voltage range of the battery is measured
as between 3 .7–7 .3 V, only program 1 can be
selected .
12 V batteries
If a battery is recognised in the critical voltage
range of between 7 .3–10 .5 V, the appliance
checks whether a fully charged 6 V battery, or a
discharged 12 V battery is present . After pressing
the program selection button
the appliance carries out a control measurement
for about 90 sec .
The display shows:
If after about 90 sec . between 7 .3–7 .5 V are
detected, the 12 V battery is defective .
The appliance goes on standby.
from
lights up . When
) . The
are empty .
to select a program,
GB │ MT │ 35 ■