Graco 234113 Operation page 9

5. Turn flow control to PRIME. Allow fluid to flow constantly.
6. Turn flow control to LOW/MED/HIGH.
7. Trigger gun into waste container. When flushing material
appears, direct fluid into flushing container.
WARNING MISE EN GARDE
ADVERTENCIA ADVERTÊNCIA
8. Place siphon tube in material.
9. Turn flow control to PRIME. Trigger gun again into flushing
fluid container until steady flow of material appears.
Turn flow control to LOW/MED/HIGH.
Inspect fittings for leaks. Do not stop leaks with your hand or a rag! If leaks occur,
turn sprayer OFF immediately. Do Pressure Relief in Cleanup, 1. – 2. on page 12. Tight-
en leaky fittings. Repeat Startup, 1. – 5. If no leaks, continue to trigger gun until system
is thoroughly flushed. Proceed to 7.
TI3069A
TI3073A
MATERIAL
TI3071A
FLUSH
TI3070A
FLUSH
TI3072A
9
309663