Duplex Control Module (Dcm); Printer - Trane CVHE Troubleshooting Manual

Duplex Control Module
(DCM)

Printer

The printer settings in the service settings menu must be set exactly the same on the printer
being used. This includes:
~ printer baud rate
~ printer parity
~ printer data bits
~ printer stop bits
~ printer handshaking
The above settings are usually configured on a printer by DIP switches. The dip switch settings
can be found in the manufacturers information provided with the printer.
Dip switch settings for the Okidata Microline 184 turbo printer follow:
Table 3
Switch Bank1
Parity Type
odd parity
even parity
Parity
No parity
With parity
Data Bits
8 bits
7 bits
Handshaking
Ready/Busy
X-on/X-off
Test Select
Circuit
Monitor
Mode Select
Print mode
Test mode
CVHE-SB-32A
Switch -1
SW1 ON
Switch -1
SW1 OFF
Switch 1
on
off
Switch 2
on
off
Switch 3
on
off
Switch 4
on
off
Switch 5
on
off
Switch 6
on
off
-2 -3
OFF ON
-2 -3
OFF ON
48