Husqvarna HG 125 B Original Instructions Manual page 16

Abrasive TYPE 41/1A and
27A Wheel Assembly
Using the optional Type 41/1A wheel guard,
it is possible to perform limited cutting on
small stock such as metal tubes, piping or
rebar.
Do not attempt to cut large stock or sheets
of metal as this tool is not designed to be a
dedicated cutting tool.
cutting.
TO ATTACH ABRASIVE WHEEL (FIG. 5)
1.Disconnect battery pack from tool.
2.Be sure that wheel guard is in place for
cutting.
3.Place backing flange and grinding wheel on
the spindle. Make sure the backing flange
locks into the base of the spindle.
4.Thread on the quick-clamping nut. While
holding the spindle lock, tighten nut using
the fold-up bar.
TO REMOVE: Reverse procedure.
Type 41/1A Abrasive
Straight Grinding Wheels
for straight/die grinding. This tool is not
designed for use with Type 41/1A abrasive
straight/die grinding wheels.
Always use Type 41/1A
protection guard for
Do not use Type 41/1A
abrasive wheels designed
Assembly
TYPE 41/1A
CUTTING WHEEL
TYPE 27A
CUTOFF
WHEEL
-16-
SPINDLE
TYPE 41/1A
WHEEL GUARD
(OPTIONAL)
BACKING
FLANGE
QUICK-
CLAMPING NUT
QUICK-
CLAMPING NUT
FIG. 5
TYPE 27A
CUTOFF
WHEEL
SPINDLE
BACKING
FLANGE