Husqvarna HG 125 B Original Instructions Manual page 14

Quick-Clamping Nut
Use the quick-clamping nut to secure the
grinding/cutting disc without the need for
additional tools. Only use the quick-clamping
nut for grinding/cutting discs up to a
maximum diameter of 5".
• The quick-clamping nut may be used only
for grinding or cutting discs.
• Only use quick-clamping nuts that are in
good working order and not damaged.
• When screwing on, make sure that the
printed side of the quick-clamping nut is
not facing the grinding disc.
Press the spindle lock
button to lock the
grinding spindle. To
tighten the quick-
clamping nut, lift the
fold-up bar and turn
the quick-clamping
nut firmly clockwise.
Then push down the
fold-up bar to secure
the quick-clamping
nut. It is not sufficient
to tighten the disc
along the edge.
Assembly
A properly secured,
undamaged
clamping nut can be
removed by hand. To
do this, lift the fold-up
bar and turn the
quick-clamping nut
firmly anticlockwise. If
the quick-clamping
nut is stuck, do not
attempt to loosen it
with a tool – always
use a
spanner.
Operating Speed rated at least equal to the
maximum speed marked on the power tool.
This speed is based on the strength of the
wheel. It is not meant to imply a best or most
efficient operating speed. Do not exceed the
Maximum Safe Operating Speed.
-14-
quick-
two pin
Only use accessories
with Maximum Safe