Technical Data; Troubleshooting - DeWalt DWV112 Instruction Manual

TECHNICAL DATA

TYPE
Voltage V
Frequency Hz
Power W
Motor
Tank Capacity L (Gallons)
Hose diameter in (mm)
Hose length in. x Ft.
Weight kg (lbs)
PROBLEM
Motor does not run
Suction capacity decreases
Vacuum stops running
Dust comes out while vacuuming
DWV112
AR B2 B3 BR B2C
220 220 120 127 220
50 60 60 60
1250
Single Stage
12
2-1/2" (63,5)
2 1/2 x 7
11,3 (25)

TROUBLESHOOTING

Check power cord, plugs and outlet.
Ensure the on/off switch is in the ON position (I)
Remove blockages in the suction nozzle, suction tube, suction hose or filters
Replace the paper or fleece bag
Check for proper installation of the filters.
Clean or replace the filters.
Empty canister, refer to Emptythe tank under Operating.
Thermal overload has been tripped:
1. Turn the vacuum off and disconnect vacuum cleaner from power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an appropriate outlet and turn on/off switch to the
ON position ( I) to test. If vacuum will not restart call 1-888-899-0146
Check for proper installation of the filters.
Ensure filters are not damaged; replace if necessary.
Ensure filter seals are in place and are secure.
Troubleshooting

WARNING: to reduce the risk of injury from
moving parts and/or electrical shock, turn
power switch off and disconnect grounded
plug from electrical outlet before performing
troubleshooting checks.
50
Minor problems often can be fixed without calling customer
service
POSSIBLE SOLUTION
ENGLISH
25