Remove the side cowling (Left).
A: Side cowling (Left)
B: 6 × 20 mm stepped Allen screw
C: 5 × 18 mm stepped Allen screw
D: Fastener
E: Boss
Bleed the clutch fluid circuit in the same manner as the
brake air bleeding procedure.
NOTE:
Do not drop clutch fluid level below lower level
line while bleeding air.
After bleeding the clutch fluid circuit, tighten the
bleeder valve to the specified torque.
Reinstall the rubber protective cap.
Be sure to check the fluid level in the reservoir tank.
Clutch air bleeder valve:
Reinstall the side cowling (Left).
Reinstall the upper panel (Left).
Reinstall the meter upper panel and meter lower panel.
A: Bleeder valve
FRONT BRAKE LEVER
Make sure the front brake lever position is correct.
The standard setting for this motorcycle is as indicated
in the table below.
Standard setting
A: Adjuster
19
6.0 N·m (0.60 kgf-m, 4.5 lb-ft)
Position 3