CLUTCH AIR BLEEDING
Any air which may have been trapped in the clutch fluid
circuit must be bled completely.
If the clutch lever feels spongy or weak, then most
likely there is air in the hydraulic circuit.
To bleed the air from the clutch fluid, use the following
procedure:
Remove the meter lower panel.
NOTE:
To remove the fastener, pull the center pin and
pull out the fastener.
A: Meter lower panel
B: Stepped Allen screw
C: Fastener
Remove the meter upper panel.
NOTE:
To remove the fastener, push in the center pin
and pull out the fastener.
A: Meter upper panel
B: Fastener (Large)
C: Fastener (Small)
D: Guide
Remove the upper panel (Left).
A: Upper panel (Left)
B: Tapping screw
C: Stepped Allen screw
D: Hook
18