Advertisement
Hardware Installation
Chapter3
The basic steps for hardware installation is as following;
1) Turn off your computer. Then open the case of your Computer.
2) Put off the metal cover on the PCI bus slot which you would like to install the modem.
3) Plug the internal modem, fasten the modem after confirming you have plugged well. Put back the
case.
4) Plug one end of the phone line into LINE port on the modem. If you want to use a telephone on
the same line, use the RJ11 cable attached to connect the telephone to the PHONE port of the
Modem.
Software Installation
Chapter4
Assuming your system is windows 2000, other windows system is similar.
1) When power on your computer, Windows 2000 will detect a new hardware, PCI Device, click Next.
2) Device Driver Wizard window will appear. Choose the default option Search for the best driver
for your device (Recommended) and click the Next button.
3) Choose Specify a location, Click Next.
4) Input the directory of the driver or click Browse of the driver directory of your CD driver. (The details
please refer to the directory label on the CD bag.)
5) Click Next, Windows will prompt the digital-signature has not been found, Click Yes.
6) Click Finish.
In Win98, the driver installation is similar to the above; you may choose the default option to finish the
installation. After the installation, if there is a prompt to install "WAVE DEVICE FOR VOICE MODEM"
just cancel it.
Dial for connection to Internet
Chapter5
1)
In Win98, please confirm that you have installed the "Dial network" in the Windows components
"Communication".
2)
In Win98, please confirm that you have installed TCP/IP protocol.
3)
To establish Dial-connection (e.g. Win2k).
a)
Go into Control Panel\Network and Dial-up Connections, double-click New connection, click
Next.
b)
Choose Dial to specified Network, click Next.
c)
Input the telephone number dialed, click Next.
d)
You may allow all users in Win2k or only you to use the connection. Click Next.
e)
Input the name of the Dial Connection.
f)
Finish.
The basic configurations have been finished. You can dial to connect to the Internet. You can also click
the Property in the Connection dialog box to set other configurations.
2
Advertisement
