Table of Contents
Advertisement
20. Remove one of the three fitter plate screws located
on the underside of the motor assembly and loosen
the other two screws. Then connect the single pin
connectors from the switch housing to the single
pin connectors from the switch housing cap -- blue
to black and white to white. Ensure the plugs
connect tightly. Align the screw holes of the light kit
with the loosened fitter plate screws. Then replace
and tighten all fitter plate screws (Fig. 20).
21. Install the bulbs (Fig. 21).
Important: When replacing the bulbs, let the bulbs and
light kit cool before touching them.
Warning: Bulbs contain mercury. Manage in
accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow cleanup
procedures provided at www.epa.gov/cflcleanup or
1-866-284-4010.
22. Lift the glass globe up to the light kit and twist tightly
in a clockwise direction until it is secure (Fig 22)
LIGHT KIT INSTALLATION
.
13
13
Fig. 20
Light Kit
Screws
Fig. 21
Socket
Fig. 22
Glass Shade
Bulb
Light Kit
Trim
Advertisement
Table of Contents
