To install the fan without a light kit, skip to Step 28.
22. Remove screws and washers from switch housing.
Then connect the single pin connectors from the
switch housing to the single pin connectors from
the light kit -- black to black and white to white.
Ensure the plugs connect tightly (Fig. 22).
Washer
Screw
23. Align the notch in the switch housing cap with
the reverse switch. Then lift the switch housing
cap and re-insert the three screws and washers
that were previously removed. Use a Phillips
screwdriver (not included) to secure all screws.
(Fig. 23).
Washer
Screw
24. Install each bulb (Fig. 24).
Important: When replacing the bulb, allow bulb and
light kit to cool before touching.
LIGHT KIT INSTALLATION
14
Fig. 22
Screw and
Washer
Light Kit
Fig. 23
Screw
Notch
Fig. 24
Bulb
Reverse
Switch
Switch
Housing
Cap