Blomberg DW 14110 NBL00 Installation Manual

Hide thumbs Also See for DW 14110 NBL00:

Advertisement

Dishwasher
Installation Manual
FOR MODELS
DW 15120 NBL00
DW 14110 NBL00
DW 15121 NBL00
DW 14120 NBL00
DW 15140 NBL00
DW 14140 NBL00
DW 15141 NBL00
DW 15110 NBL00
DW 34100 NBL00
DW 15111 NBL00
DW 34110 NBL00
DW 35120 NBL00
DW 34120 NBL00
DW 35140 NBL00
DW 34140 NBL00
DW 36100 NBL00
DW 35100 NBL00
DW 36101 NBL00
DW 35110 NBL00
DW 36110 NBL00
USA
DW 36111 NBL00
DW 36120 NBL00
DW 36121 NBL00
DW 36140 NBL00
DW 36141 NBL00

Advertisement

Table of Contents
loading

Summary of Contents for Blomberg DW 14110 NBL00

  • Page 1 Dishwasher Installation Manual FOR MODELS DW 15120 NBL00 DW 14110 NBL00 DW 34110 NBL00 DW 35120 NBL00 DW 36111 NBL00 DW 15121 NBL00 DW 14120 NBL00 DW 34120 NBL00 DW 35140 NBL00 DW 36120 NBL00 DW 15140 NBL00 DW 14140 NBL00...
  • Page 2 Installation Manual For Dishwasher Models DW 14110 NBL00 DW 15110 NBL00 DW 15121 NBL00 DW 14120 NBL00 DW 15111 NBL00 DW 15140 NBL00 DW 14140 NBL00 DW 15120 NBL00 DW 15141 NBL00 DW 34100 NBL00 DW 35100 NBL00 DW 36100 NBL00...
  • Page 3 To prevent accidents, which could cause serious injury or death, as well as machine damage read these instructions before installation and or use. Contents...
  • Page 4: Important Safety Instructions

    INTRODUCTION DANGER WARNING Ý Notice CAUTION 1. IMPORTANT SAFETY INSTRUCTIONS Ý Notice : WARNING When installing the dishwasher, follow basic precautions, including the following:...
  • Page 5: Inspect The Dishwasher

    Ý Notice : INSPECT THE DISHWASHER Ý Notice :...
  • Page 6: Tools Which May Be Needed

    TOOLS WHICH MAY BE NEEDED MATERIALS WHICH MAY BE NEEDED...
  • Page 7: Manual Bag

    MATERIALS SUPPLIED PARTS SUPPLIED MANUAL BAG DISHWASHER PARTS BAG 1 DISHWASHER PARTS BAG 2 ”(196,5mm)
  • Page 8: Dishwasher Specifications

    DISHWASHER SPECIFICATIONS 2 4 ” ( 6 1 2 4 ” ( 6 1 TECHNICAL FEATURES ” m Ý Notice ENCLOSURE PREPARATION Ý Notice : ELECTRICAL PREPARATION WARNING To avoid electrical shock and/or a fire hazard, make sure electrical work is properly installed. Only qualified electricians should perform electrical work.
  • Page 9: Preparation For Installing Mounting Brackets

    PREPARATION FOR INSTALLING MOUNTING BRACKETS WARNING Dishwasher must be secured to adjacent cabinetry using the mounting brackets provided. Failure to do this may cause damage to property or bodily injury. Ý Notice :...
  • Page 10: Adjusting Height

    ADJUSTING HEIGHT INSTALLING THE FOOT SUPPORTS ” ( 5 0 m m ) ” ( 5 0 m m ) ” (50mm) ” (50mm) ” (50mm) ” (50mm) Ý Notice :...
  • Page 11: Installing The Side Trim Strips

    Ý Notice : INSTALLING THE SIDE TRIM STRIPS Ý Notice :...
  • Page 12: Preparing The Water Connection (A)

    PREPARING THE WATER CONNECTION (A) WARNING Installation should be performed by a qualified installer. Work by unqualified persons could be dangerous and may void the warranty. If the dishwasher is installed in a location that experiences freezing temperatures (e.g. in a vacation home, cabin etc.), you must drain all the water from the dishwasher's interior.
  • Page 13: Drain Preparation

    DRAIN PREPARATION A, B, C Ý Notice : The total length of the drain hose is 76 ” (1950mm.) If a hose extension is required, a drainage hose of equal quality must be used. The maximum length must not exceed 157 ”...
  • Page 14: Placement Of Dishwasher Into The Opening

    PLACEMENT OF DISHWASHER INTO THE OPENING CAUTION Make sure all hoses and electrical wire are pulled through the side opening of the cabinet; no hoses are kinked and all slack taken out as shown in the above figure. DRAIN HOSE CONNECTION, WATER SUPPLY &...
  • Page 15: Water Supply Connection

    WATER SUPPLY CONNECTION BRAIDED HOSE/COPPER TUBING CAUTION Hot water supply line: Use minimum 3/8” O.D. copper tubing or metal braided dishwasher supply line. Temperatures required for soldering and sweating will damage the dishwasher’s water inlet valve so if any such operation is needed, keep the heat source min.
  • Page 16 WARNING Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt whether the appliance is properly grounded. Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
  • Page 17: Fasten Junction Box

    FASTEN JUNCTION BOX READJUSTING FOOT Ø 1 / 8 " Ø 1 / 8 " Ý Notice : Ø 1 / 8 " Ø 1 / 8 "...
  • Page 18: Adjusting The Movable Toe Kick

    ADJUSTING THE MOVABLE TOE KICK Ý Notice :...
  • Page 19: Installing The Outer Door

    INSTALLING THE OUTER DOOR (DW 34100, DW 35100, DW 36100, DW 36101)
  • Page 20 Ø "...
  • Page 22 Ø 3 / 16 " Ø 3 / 16 "...
  • Page 23 ADJUSTING DOOR TENSION WITH CUSTOM WOODEN DOOR (DW 34100, DW 35100, DW 36100, DW 36101) 0 kg...
  • Page 24 Ý Notice : A B C Ø 1 / 8 " 3 / 8 ” (10mm)
  • Page 25: Installer Checklist

    Ý Notice : Ý Notice : SELF HELP HINTS: INSTALLER CHECKLIST The power indicator light doesn’t come on: Check to make sure the breaker to the dishwasher is in the on position. Check all the wire connections in the junction box are tight and not loose.

Table of Contents