Table of Contents
Advertisement
r Connecting terminals
1
<SDI 输入> terminal
This is a terminal to input the SDI signal.
2
<RGB 输入> terminal
This is a terminal to input the RGB signal or YC
signal.
3
<DVI-D 输入> terminal
This is a terminal to input the DVI-D signal.
4
<HDMI 输入> terminal
This is a terminal to input the HDMI signal.
5
<DIGITAL LINK> terminal
This is a terminal to connect a device that transmits video signal
via the LAN terminal. Also, this is the LAN terminal to connect to
the network.
6
<局域网> terminal
This is the LAN terminal to connect to the network.
7
<输出电压> terminal
This is the USB terminal dedicated for power supply. (DC 5 V,
maximum 2.0 A)
Use this terminal when a power supply is required to wireless
display adapters and wireless LAN/Ethernet converters, etc.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
f When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [NORMAL], power can be supplied by using the <输出电压> terminal
even while the projector is in standby mode. If [ECO] is set, power cannot be supplied in standby mode.
f To transmit the Ethernet and serial control signals using the <DIGITAL LINK> terminal, set the [NETWORK] menu → [NETWORK
CONTROL] → [TYPE SELECT] to [DIGITAL LINK] or [LAN & DIGITAL LINK].
f To transmit the Ethernet signal using the <局域网> terminal, set the [NETWORK] menu → [NETWORK CONTROL] → [TYPE SELECT] to
[LAN] or [LAN & DIGITAL LINK].
f The <DIGITAL LINK> terminal and the <局域网> terminal are connected inside of the projector when the [NETWORK] menu → [NETWORK
CONTROL] → [TYPE SELECT] is set to [LAN & DIGITAL LINK]. Do not directly connect the <DIGITAL LINK> terminal and the <局域网>
terminal using a LAN cable. Construct the system so that it is not connected to the same network via the peripherals such as the hub or the
twisted-pair-cable transmitter.
Chapter 1 Preparation — About your projector
1
2
3
7
8
9
C
/YP
P
B
R
B
R
4
5
6
10
11
8
<串口/多台投影机同步输入> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
This terminal is also used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the effects using the shutter function including the fade in/fade
out with a system using multiple projectors.
9
<串口/多台投影机同步输出> terminal
This is a terminal to output RS-232C compliant signal input to
the <串口/多台投影机同步输入> terminal.
This terminal is also used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the effects using the shutter function including the fade in/fade
out with a system using multiple projectors.
10 <REMOTE 1 输入> terminal
This is a terminal to remotely control the projector using the
external control circuit.
11 <REMOTE 2 输入> terminal/<REMOTE 2 输出> terminal
These are terminals to connect the remote control for serial
control in a multiple projector environment.
ENGLISH - 27
Advertisement
Table of Contents
