Initial Operation - IVT AC-24L Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

∙

When using the machine for different purposes

(inflating, supplying pneumatic instruments and other

units utilizing compressed air power, painting, washing

etc...), the user is supposed to be aware of safety

regulations for each specific case.

∙

Ensure all air tools and accessories used are

designed for the working pressure or are supplied via a

pressure regulator.

∙

The machine is intended for continuous unattended

operation. Ensure that the machine is mounted far

from inflammables and no external factors prevent the

normal cooling of the machine.

WARNING! Operation in hazardous

locations is not permitted.

∙

The machine must not be used in the areas with

dust or containing explosive gases and vapours of

aggressive substances.

∙

It is prohibited to leave the machine in the rain or

snow as well as to operate it in high humidity.

∙

Do not touch the machine with wet hands.

WARNING! Do not direct a jet of

compressed air at people, animals

or at your own body. Do not direct

a jet of compressed air (or sprayed

substances) at the machine.

∙

Ensure all screwed connections are fully tightened

at all times.

∙

Do not attempt to repair the device yourself! Only

trained specialists are permitted to service or repair

compressors, pressure vessels and air tools.

CAUTION!

the

surfaces

compressed air! Pay attention not to

touch hot surfaces or hot parts. Let

the device cool off before servicing.

WARNING! Never inhale air from the

compressor either directly or from

a breathing device connected to the

compressor. Work in an area with

good cross-ventilation.

∙

Use safety equipment! Wear hearing protection.

Wear safety glasses. Wear mask respirator when work

generates dust or mist detrimental to health.

∙

Please note that the compressor will start

Risk

burns

from

parts

carrying

automatically when the pressure falls off to a minimum! –

disconnect from power supply prior to any servicing. Start

the machine only when a tool is connected. Connect and

disconnect the tool only when the machine is off.

∙

Never unscrew any connecting parts when the

receiver is in pressure condition.

∙

Do not leave compressed air in the receiver.

Transferring or keeping machine with air not released

from the receiver is prohibited.

∙

After the work is finished, wait until the machine is

cooled down. Only then, the machine may be covered

or encased in the protective casing.

∙

ATTENTION! The compressor should be located

as close to the main supply as possible. NEVER USE

an extension cord with this product. Use additional air

hose instead of an extention cord to avoid power loss

and permanent motor damage.

∙

ATTENTION! This appliance must be earthed

with electrical grounding: failure to provide adequate

grounding to this product could result in serious injury or

death from electrocution.

UNPACKING

When unpacking, check to make sure that all

components are included. Refer to the drawings on this

manual. If any parts are missing or broken, please call

an IVT assistance center.

ASSEMBLY INSTRUCTIONS

When performing the following operations, do not apply

excessive force to tight fasteners. Inobservance of this

requirement may lead to the damage of threaded joints.

Important! You must fully assemble the appliance

before using it for the first time.

Mounting the wheels (20) and rubber feet (18) [F1]

In case the wheels (20) are not mounted on the

machine, after unpacking, mount the wheels (20) and

rubber feet (if present) appropriately.

Mounting the air filter (17)

If not already mounted, it's necessary to install the air

filter (17) on the machine.

∙

First, remove the transportation stop with a

screwdriver or similar, and then screw the air filter (17)

securely to the cylinder head.