Toyotomi SATORI ECO II Series User Manual page 67

Indoor unit does not
accept remote control-
ler's signal or remote
controller does not
work
If any of the following cases occur, turn off the unit, pull out the plug from the
socket and contact the authorized service of
Γ.Ε.ΔΗΜΗΤΡΙΟΥ Α.Ε.Ε. ℡ +30 210 5386490,
TOYOTOMI ITALIA S.R.L. ℡ +39 039 6080392,
TOYOTOMI EUROPE SALES B.V. ℡ +31 (0)413 82 02 95,
TOYOTOMI EUROPE SALES SPAIN S.A. ℡ +34 91 6895583
§
There is signifi cant interference (e.g. static electricity,
constant voltage)
ü
Turn off the air conditioner, pull out the plug from
outlet. Wait 3 minutes then put the plug to the outlet
and restart the function of the air conditioner
§
Remote controller is out of range
ü
The distance between signal center and receiving
window should be no more than 8m
§
There are obstacles between signal center and
window receiver
ü
Remove obstacles
§
Signal center of remote controller cannot
communicate with window receiver of the indoor unit
ü
Choose the right angle where signal center of
remote controller can communicate with window
receiver of indoor unit
§
The display on remote controller is fuzzy or there is
no display at all
ü
Check the batteries. If their power is low, replace
them
§
No display on remote controller
ü
Check if the remote controller is damaged. If yes,
please replace it
§
There is fl uorescent lamp in the room
ü
Take remote controller closer to the window receive
of indoor unit
ü
Turn of the fl uorescent lamp and try again
67
GB