Advertisement
4
Functions
Hands free Communication
This device provides hands free communication between the black and white monitor
and the outdoor intercom unit. With a press of a button, you can communicate
with the visitor at the door.
Automatic Display
When the visitors press the doorbell button , the bell will ring and a picture of the
visitor will be automatically displayed . You can safely identify the visitor before talking
or opening the door.
Unlock Button
With a button for opening an electronic door latch, you are able to open the door from the
LCD monitor without going directly to the door.
* Note: This is an optional extra available from Swann. (SW-D-LOCK)
Night Vision
The 6 infrared LEDs on the camera allows you to recognize the visitor during times of low light.
* Night vision distance will vary with the amount of available light.
We, Swann Communications of 10612 Shoemaker Avenue, Bldg A, Santa Fe Springs, CA 90670 USA, declare under
our sole responsibility that the product:
This product meets the requirement specified in Part 15 of FCC Regulation. Operation rests with the following two
conditions:
(1) The equipment should not cause any harmful interference;
(2) The equipment must receive and process any interference, including any possible interference caused by
operation mistakes. After testing the product, we confirm that it complies with the provision for class C digital
equipment in the 15th part in FCC regulation; and the receiver complies with the limitation for class B digital
equipment in Part 15 of FCC regulation. The product generates, applies and emits radio waves. It might cause
harmful interferences to wireless communication if not be installed and used following the description of the manual.
The product may interference in residential area, and the customer should take remedies to eliminate the
interference at their own costs. If the product causes any harmful interference to wireless equipment of disturbs the
receiving of TV signals (it can be identified by turning on and off the product), you can solve the trouble by following
methods:
(1) Re-adjust the product or put it in another place;
(2) Extend the distance between the equipment interfered and the product; and
(3) Refer to dealers or experienced radio electrician for help
This product complies with standards including Low Voltage Device Directive 73/23/EEC;
and
R&TTE
Directive 1999/5/EC. It passed the subject tests by authority concerned and it authorized to bear
FCC Notice
SW244-BVD
CE Notice
EMC
Directive 89/336/EEC
Operation
Calling by the Visitor
A visitor presses the
"call" button on the
intercom.
Once
you p
ress "talk" button to
automatically
in 2 minutes
When the visitor presses the "call" button, t
answers, the monitor will automatically go back into standby mode after 60 seconds.
Other operations
Warning button
If you get malice visitors, you can press warning button. The intercom unit will give an audible alarm
and bring attention to area around the intercom unit.
Adjustable volume/contrast
If you think the monitor volume is not loud enough or the picture shown on the screen is too bright,
you can alter this by adjusting the volume or contrast wheel found underneath the monitor
CE
mark.
The
door phone will ring and
the
visitor
is displayed on
the
monitor.
communicate with the visitor, the monitor will be shut down
.
he picture will be displayed on the monitor. I
9
Press
the talk
"
" button
to
communicate with the visitor.
f no one
.
Advertisement
