Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 4500-D Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours (And after every washing).
Grease specification: No. 2 lithium grease
The grease fitting locations and quantities are as follows:
•
Brake-shaft pivot bearings (5) as shown in
Figure 32
•
Rear-axle-pivot bushings (2) as shown in
Figure 33
•
Steering-cylinder ball joints (2) as shown in
Figure 32
1. Top fitting on kingpin
Figure 33)
•
Tie-rod ball joints (2) as shown in
•
Kingpin bushings (2) as shown in
Important: The top fitting on the kingpin should
only be lubricated annually (2 pumps).
•
Lift-arm bushings (1 per deck) as shown in
•
Lift-cylinder bushings (2 per deck) as shown in
41
Figure 34
Figure 34
Figure 34
Figure 34
Figure 35
Figure 35
Figure 35