Networking Via Ethernet; Ip Settings; Diagnostics - Bosch AVENAR panel 8000 Manual

30 pt-BR | Networking via Ethernet
6

Networking via Ethernet

6.1

IP settings

To modify values for Ethernet settings or to configure these for the first time, select in the
start menu:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Aviso!
i
Changes to Ethernet settings take effect after restarting the panel.
6.2

Diagnostics

Diagnostics information and help materials for pinpointing problems in a network can be
found under menu item Diagnósticos - Serviços de rede. Information is provided on the
following topics:
–
–
–
–
2023-08 | 8.0 | F.01U.378.877
Configuração
Serviços de rede
Ethernet. The Configurar Ethernet screen is displayed.
Activate the checkbox Utilizar definições de Ethernet.
Select Definições de IP. The values for IP address, network screen, default gateway,
multicast address and port number are indicated. When you commission the panel
controller for the first time, all values are set to "0".
Select Predefinições to overwrite these values with the default settings saved in the
panel controller (recommended!). The IP address in this case corresponds to the stored
default IP address, the last number of which matches the physical node address (PNA/
RSN) that was set during installation at the panel controller.
If the planned configuration requires a change to the default values:
Touch the field containing the value to be changed. Use the arrow keys on the operating
panel to select the desired numbers and modify the values using the number keys on the
alphanumeric keypad.
Or:
Touch the Alterar field. Touch the field containing the number block to be changed. Use
the arrow keys on the operating panel to select the desired numbers and modify the
values using the number keys on the alphanumeric keypad.
Touch OK to apply the changes or Cancelar to discard the changes. You are returned to
the initial Configuração do IP screen.
Select OK to apply the changes to the IP settings or Cancelar to discard the changes. You
are returned to the Configurar Ethernet screen.
Select OK to confirm application of the Ethernet settings (Utilizar definições de
Ethernet) or Cancelar to exit the screen without activating the Ethernet settings.
Tabela de Routing
Information concerning the accessibility of all nodes within the system network via the
respective interface.
Portas Ethernet
Information concerning different parameters and the status of the two Ethernet
interfaces available at the panel controller.
Enviar comando Ping
Sending of a ping command to a specific IP address to check the availability of other
nodes in the network.
Verif de consistência
Manual do utilizador
AVENAR panel 8000 | AVENAR panel 2000 |
AVENAR keypad 8000
Bosch Sicherheitssysteme GmbH