Adjusting The Height Of Cut - Toro 72923 Operator's Manual

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has 2 positions, and is used with
the deck-lift pedal. There is a L
an U position for the transport position of the
NLOCK
mower deck (Figure 27).
Figure 27
Transport-Lock Positions
1. Transport lock knob
2. L position—The
OCK
mower deck locks into the
transport position.
position and
OCK
g229103
3. U position—The
NLOCK
mower deck does not lock
into the transport position.
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inch) cutting height
position) as shown in
3. To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
28).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (Figure
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
1. Deck-lift pedal
2. Cut-of-height pin
31
Figure 28.
(Figure
28).
Figure 28
3. Transport lock
g027343