Hour Meter - Toro 72923 Operator's Manual

Once the MIL illuminates, make initial troubleshooting
checks; refer to the MIL section under
(page 87).
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.

Hour Meter

For Machines with a Smart Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine
is running. Use these times for scheduling regular
maintenance (Figure 7).
The hour meter displays when you are operating
the machine and momentarily when you shut off the
engine. The display turns off after 5 minutes.
Refer to the Software Guide for more information.
1. Safety-interlock indicators
2. LED status light
LED Status Light
The LED is multi-colored to indicate the system status
and is located on the right side of the panel.
•
Solid Green—indicates normal operating activity.
•
Blinking Red—indicates a fault is active.
•
Blinking Green and Orange—indicates a clutch
reset is required.
•
Solid Red—indicates maintenance is required.
Refer to the Software Guide for more information.
Fuel Gauge
When the fuel-tank level is low, the LED status light
flashes a red light and the fuel-level symbol on the
screen flashes.
Troubleshooting
Figure 7
3. Information screen
Refer to the Software Guide for more information.
Safety-Interlock Indicators
There are symbols on the hour meter that indicate with
a black bar that the interlock component is positioned
correctly (Figure
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction
Neutral-Lock Position
Move the motion-control levers outward from the
center to the N
the machine (Figure
motion-control levers into the N
when you stop the machine or leave it unattended.
Parking-Brake Lever
Whenever you shut off the engine, engage the parking
brake to prevent accidental movement of the machine.
Fuel-Shutoff Valve
Close the fuel-shutoff valve when transporting or
storing the machine; refer to
Valve (page 36).
g231075
18
7).
- position when exiting
EUTRAL LOCK
24). Always position the
EUTRAL
Using the Fuel-Shutoff
(Figure 4).
- position
LOCK