Projectile Hazards; Operating Hazards; Repetitive Motions Hazards; Accessory Hazards - Stanley 74202 Instruction Manual

1.2 Projectile Hazards

• Disconnect the air supply from the tool before performing any maintenance, attempting to adjust, fit or
remove a nose assembly or accessories.
• Be aware that failure of the workpiece or accessories, or even of the inserted tool itself can generate high-
velocity projectiles.
• Always wear impact-resistant eye protection during operation of the tool. The grade of protection
required should be assessed for each use.
• The risks to others should also be assessed at this time.
• Ensure that the workpiece is securely fixed.
• Check that the means of protection from ejection of fastener is in place and is operative.
• DO NOT operate a tool that is directed towards any person(s).

1.3 Operating Hazards

• Use of the tool can expose the operator's hands to hazards, including crushing, impacts, cuts and
abrasions and heat. Wear suitable gloves to protect hands.
• Operators and maintenance personnel shall be physically able to handle the bulk, weight and power of
the tool.
• Hold the tool correctly; be ready to counteract normal or sudden movements and have both hands
available.
• Keep tool handles dry, clean, and free from oil and grease.
• Maintain a balanced body position and secure footing when operating the tool.
• Release the start-and-stop device in the case of an interruption of the air supply.
• Use only lubricants recommended by the manufacturer.
• Contact with hydraulic fluid should be avoided. To minimise the possibility of rashes, care should be taken
to wash thoroughly if contact occurs.
• Material Safety Data Sheets for all hydraulic oils and lubricants is available on request from your tool
supplier.
• Avoid unsuitable postures as it is likely for these positions not to allow counteracting of normal or
unexpected movement of the tool.
• If the tool is fixed to a suspension device, make sure that the fixation is secure.
• Beware of the risk of crushing or pinching if nose equipment is not fitted.
• DO NOT operate tool with the nose casing removed.
• Adequate clearance is required for the tool operator's hands before proceeding.
• When carrying the tool from place to place keep hands away from the trigger to avoid inadvertent
activation.
• DO NOT abuse the tool by dropping or using it as a hammer.

1.4 Repetitive Motions Hazards

• When using the tool, the operator can experience discomfort in the hands, arms, shoulders, neck or other
parts of the body.
• While using the tool, the operator should adopt a comfortable posture whilst maintaining a secure
footing and avoiding awkward or off-balance postures. The operator should change posture during
extended tasks; this can help avoid discomfort and fatigue.
• If the operator experiences symptoms such as persistent or recurring discomfort, pain, throbbing, aching,
tingling, numbness, burning sensations or stiffness, these warning signs should not be ignored. The
operator should tell the employer and consult a qualified health professional.

1.5 Accessory Hazards

• Disconnect the tool from the air supply before fitting or removing the nose assembly or accessory.
• Use only sizes and types of accessories and consumables that are recommended by the manufacturer of
the tool; do not use other types or sizes of accessories or consumables.
E N G L I S H
7