Guest Check (Glu/Pblu); Glu/Pblu System - Sharp UP-700 Instruction Manual

Guest Check (GLU/PBLU)

Two different guest check entry systems are available: the GLU system and previous balance lookup
(PBLU) system. It depends on how your POS terminal has been programmed which of these is used.
(Contact your authorized SHARP dealer for this selection.)
If this system is selected, the balance due and the details of the order are placed in the
GLU system:
guest check file. The information can be automatically recalled by pressing the
or entering a GLU code when additional ordering or finalization is required.
PBLU system: If this system is selected, the previous balance is stored in the previous balance lookup file
(PB lookup file). The information can be automatically recalled by entering a previous
balance lookup code (a PBLU code) when additional ordering occurs.

GLU/PBLU system

New guest
For a new guest;
For automatic GLU/PBLU
code generation
*1
GLU or
PBLU code
Individual
payment
operation
for table
system
NOTE
• The GLU/PBLU code refers to a number/code that will be used whenever the guest check must be
accessed for re-ordering or final payment.
The range of GLU or PBLU codes that can be entered in each terminal can be programmed, and also can
be specified in OP X/Z mode for each server.
• Your POS terminal can be programmed for table #/PBLU codes in a sequential fashion. If your POS
terminal has not been programmed to do so, each table #/PBLU code can be entered manually.
*1 GLU/PBLU code: 1 to 9999
When the range of GLU or PBLU codes is programmed in PGM2 mode and/or specified in OP X/Z
mode, the GLU that can be entered is limited to the range.
*2 The cover count refers to the number of people in the party. When the cover count entry is
compulsory, you must enter the cover count (max.2 digits). When cover count is not compulsory,
enter the cover count and press the
times the key is pressed in table system. (When the cover count is not entered and the
SEAT
#
not pressed, the cover count is counted as 1.)
*3 Seat # entry is only for the table system.
When the seat # entry is compulsory, you must enter a seat #. To enter the first person #, enter the
seat # (max. 2 digits) and press the
and press the
SEAT
#
The number of times of the seat # entry must not exceed the previously entered cover count when it
entered.
*2
Cover count
NC
entry
*4
SRVC
*4
FINAL
[Payment operations]
Seat no. entry
IND.
PAYMENT
(max. 2 digits)
key, however, it is automatically calculated by the number of
COVER
CNT
key. To enter the second person# or later, enter the number
ENTER
key.
*3
Seat no. entry
To issue the bill
BILL
[Payment operations]
ENTER
To end individual payment
key,
GLU
RECALL
[Item entries]
BILL
key is
SEAT
#
41