Table of Contents
Advertisement
Mirrors
7
Adjusting mirrors
156
Turn the mirror to the correct
z
position.
Adjusting mirror arm
Push the protective cap 1 up-
wards above the screw con-
nection on the mirror arm.
Loosen nut 2.
Turn the mirror arm to the ap-
propriate position.
Tighten the nut to the spe-
cified tightening torque, while
holding the mirror arm in place.
22 Nm (Left-hand thread)
Push the protective cap over
https://www.motorcycle-manual.com/
the threaded fastener.
Mirror (lock nut) to
clamping piece
Headlight
Headlight adjustment for
right- or left-hand traffic
The asymmetrical low-beam
headlight dazzles the oncoming
traffic when riding in countries
which drive on the other side of
the road to that of the motor-
cycle's country of registration.
Have the headlights adjusted to
the prevailing conditions by a
specialist workshop, preferably
an authorised BMW Motorrad
Retailer.
Headlight beam throw and
spring preload
The headlight beam throw gen-
erally remains constant by adjust-
ment of the spring preload to the
load status.
Adjustment of the spring preload
is only inadequate if the payload
is very high. In this case, the
Advertisement
Table of Contents
