Wall Mounting With Screws - Samsung SMARTCAM SNH-P6410W User Manual

Wall Mounting with Screws

`
n
For more information about step of Separating the wall-mount bracket, refer to "Wall
Mounting Using Double-sided adhesive tape".
Assembling
1.
Take out screws (M3xL20), and anchors (Φ5x25mm).
2.
On a wooden wall, use screws to fix the
wall-mount bracket as shown in the figure.
Using a driver on the wall to attach it to,
fasten three screws in the three holes.
3.
If fixing on a concrete wall, use screws and anchors to fix wall-mount bracket.
First, mark on the wall as shown in the figure below.
4.
Use drill bit of 5mm diameter and drill on the
marked positions, drill to have 3 cm depth
holes. Clean the holes after drilling.
`
J
Be careful not to get injured while drilling.
5.
Insert an anchor for each hole. Fully insert
anchors by hammering lightly the anchor
head with a hammer/rubber hammer.
6.
Using a driver on the wall to attach it to,
fasten three screws in the three holes.
`
n
For further steps, refer to the instructions for
"Wall Mounting Using Double-sided
adhesive tape".
02
11