Table of Contents
Advertisement
Auto1TouchManual_2
8/13/08
2:34 PM
Instructions for Cleaning
IMPORTANT: Always unplug the appliance
before cleaning the Automatic One-Touch
Food Packaging System.
Base with Non-Slip Feet
Figure 9
Figure 10
Figure 1 1
Page 11
Carefully wash your hands before
cleaning the appliance and its
accessories.
Both before and after use, clean
the exposed surfaces of the Automatic
One-Touch Food Packaging System
using a sponge moistened with a mild,
non-abrasive dishwashing detergent.
If any liquids accidentally get inside
the appliance, discontinue use; contact
your nearest dealer or authorized
service center.
The appliance is provided with a Base
with Non-Slip Feet which is entirely
removable and can be placed on the top
rack of your dishwasher (Figure 9).
Before washing the lower part, remove
the Airtight Gaskets (Figure 10) and
Sealing Gasket (Figure 11). Clean both
gaskets using a sponge moistened with
a mild dishwashing liquid and leave them
to completely dry before positioning
them again. Once cleaning and drying
are complete, carefully fit both gaskets
back in their places. Then reinsert the
Base with Non-Slip Feet in the port
provided on the Lid.
11
Troubleshooting
1
If the Automatic One-Touch Food Packaging System does not work:
Make sure the Automatic One-Touch Food Packaging System has
been plugged in properly. Check the electrical supply by plugging in
another appliance.
The Automatic One-Touch Food Packaging System will stop
automatically if overheated. Allow it to cool down for 15 minutes and
try again.
Check for faults in the power cord or the plug. Should you detect a
fault, do not use the appliance.
2
If the Automatic One-Touch Food Packaging System fails to apply
the first seal on a bag cut from the roll:
Make sure the bag is properly positioned and not hanging over into
the Vacuum Chamber or on the airtight gasket.
3
If the Automatic One-Touch Food Packaging System does not
create a complete vacuum:
To seal the bag properly, you must make sure that the open end
remains completely inside the Vacuum Chamber.
Make sure that the Sealing Bar, the Sealing Gaskets and Airtight
Gaskets are clean.
The bag might have a hole in it. To check it, seal the bag with air
on the inside. Check closely and if possible, use bag cutter to cut off
area with hole.
4
If the Automatic One-Touch Food Packaging System does not seal
the bag properly:
If the Sealing Bar overheats and melts the bag, you may have to
raise the Lid and allow the Sealing Bar to cool down for a few
minutes.
The Automatic One-Touch Food Packaging System has a built-in
safety shutoff. Overheating will cause it to turn off automatically.
Allow the appliance to cool down for 15 minutes and try again.
5
If the Automatic One-Touch Food Packaging System bag does not
maintain a vacuum after being sealed:
Leaks along the seam may be caused by creases, crumbs, grease or
liquids. Reopen the bag, clean the upper inside part of the bag and
remove any foreign material from the Sealing Bar before resealing it.
Check that the bag has no holes in it which have caused air to leak
in. Use paper napkins to protect any sharp edges on the contents of
the bag.
12
Advertisement
Table of Contents
