Table of Contents
Advertisement
3.5 Settings
Save Favourite (
Program settings that are frequently
used can be saved (e.g. Cotton, 60°C,
1200 rpm, with Prewash and Vapour).
To program/re-program Favourite with
your own selections and save them,
proceed as follows:
1. Put machine in Stand-By mode.
2. Select your desired program settings.
3. To save favourite program, press and
hold "Vapour
2 seconds and you will hear "Bip, Bip"
sound and "Favourite" LED is flashing.
To recall the favourite wash program,
turn selector knob to "Favourite
program. You will get acknowledgement
on the screen when the Favourite
program is loaded.
App Program cycle cannot be saved
as a Favourite on the appliance.
Child Safety Lock (
Your appliance is provided with CHILD
SAFETY LOCK which permits you to
leave the appliance unsupervised with
the door closed without having to worry
that children might be injured by or cause
damage to the appliance.
Set this option after pressing the
Start/Pause touchpad.
To set "Child Lock" option:
●
To activate the function, press and
hold "Prewash" touchpad about
2 seconds until the display shows the
icon "
".
If you press any touchpad while
Child Lock is activated, the icon
"
" will flash on display
3 times along with buzzer sound.
The touchpads are locked
(except for the On/Off button).
This function remains enabled
even after the appliance is
switched off.
) Program
" touchpad about
"
) Option
●
To deactivate the function, press and
hold "Prewash" touchpad about
2 seconds until the display shows the
icon "
".
Enabling/Disabling End-Of-Wash
Buzzer
This setting permits you to either enable
or disable the buzzer at the end of the
program. As an example, you might wish
to disable this buzzer when you start a
wash when going to bed, so that when the
wash finished approximately 1 hour later,
it will not disturb you through the night.
Error warning beeps such as critical
faults are not disabled.
●
To disable the buzzer sound, press
"SensorWash (
touchpads at the same time about
3 seconds, the icon "
on display along with buzzer sound.
●
To return to default configuration
press these 2 touchpads at the same
time about 3 seconds, the icon "
will show on display along with buzzer
sound.
3.6 Start/Pause (
Add Clothes (
This touchpad has 2 functions:
1.
Start/Pause (
After you have selected the desired
program and options, press this
touchpad to start the machine. The
Start/Pause pilot light will stop flashing
and remain lit until the water level is
above the bottom edge of the door
then pilot light goes OFF.
If you have selected a "Delay Start"
option, the countdown will begin and
will be shown on the display.
17
)" and "Vapour (
)"
" will show
) and
) Touchpad
)
"
Advertisement
Table of Contents
