Connecting The Foot Control And The Power Supply; Setting Up The Telescopic Thread Stand - Singer S14-77 Instruction Manual

Connecting the Foot Control and the
Power Supply
Among the accessories you will find the power cord and the
foot control.
Note: Consult a qualified electrician if you are in doubt about
how to connect the machine to the power source. Unplug the
power cord when the machine is not in use.
For this machine, foot control model 4C-316B (110-125V),
4C-326G (230V), 4C-336G (240V) manufactured by Wakaho
Electric Ind. Co. Ltd. (Vietnam) must be used.
Before plugging your machine in, make sure the voltage is the
same as indicated on the plate under the machine.
Specifications vary from country to country.
1. Connect the foot control/electric power cord (A) to the
socket on the machine (B).
2. Plug the power cord plug into the electric outlet.
3. Push the power switch to "I" to turn on the machine (C).
4. Press the foot control to start sewing. Use the foot control
to adjust the sewing speed. The harder you press, the faster
the machine will sew. To stop the machine from sewing,
remove your foot from the control.
5. Push the power switch to "O" to turn off the machine.
Note: When the front cover is open the safety switch is activated and prevents the machine from sewing, even if the foot control is
pressed.
Note: Your machine is adjusted to provide the best stitch result at normal room temperature. Extreme hot and cold temperatures
can affect the sewn result.
For the USA and Canada
This sewing machine has a polarized plug (one blade wider than the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet. Do not modify the plug in any way.
Setting Up the Telescopic Thread
Stand
Extend the telescopic thread stand to its full height, then turn
until it clicks into place.
Place the thread spools or cones over the cone holders on the
spool pin.
If the machine is already threaded, straighten the threads to
prevent tangling.
C B
A
About Your Machine – 3
English