Table of Contents
Advertisement
en Home Connect
15.2 Home Connect Settings
You can adjust the settings and network settings for Home Connect in the basic settings for your appliance.
Setting
Selection or display
Connection to the network
– Not connected
– Connect automatically
– Connect manually
– Connected
Connection to the Home Connect
app
– Ready
– Connect
– Connected
Wi-Fi
– Off
– Activate
– On
Remote start
– Deactivated
– Manual
– Permanent
Software update
– Update available
– Start update
Remote Diagnostics
– Not authorised
– Authorised
Factory setting
1
15.3 Operating the appliance with the
Home Connect app
You can use the Home Connect app to set and start
the appliance remotely.
WARNING ‒ Risk of fire!
Combustible objects that are left in the cooking com-
partment may catch fire.
Never store combustible objects in the cooking
▶
compartment.
If smoke is emitted, the appliance must be switched
▶
off or the plug must be pulled out and the door
must be held closed in order to stifle any flames.
22
1
1
Follow the instructions in the Home Connect app.
3.
Explanation
and are displays that you cannot set.
and are displays that you cannot set.
If Wi-Fi is activated, you can use Home Connect.
In networked standby mode, the appliance requires a max-
imum of 2 W.
is a display that you cannot set.
When remote start is deactivated, you can only view the oper-
ating status of the appliance in the app.
For manual remote start, you must activate the remote start
each time before you can start the appliance via the app. If
you open the appliance door within 15 minutes of activating
remote start or of the operation ending, remote start is deactiv-
ated.
For permanent remote start, you can start and operate the ap-
pliance remotely at any time.
The setting is only displayed if an update is available.
is a display that you cannot set.
The setting is only displayed if after-sales service is attempting
to access the appliance.
Requirements
¡ The appliance is switched on.
¡ The appliance is connected to your home network
and to the Home Connect app.
¡ In order to be able to set the appliance via the app,
the manual or permanent remote start must be se-
lected in the basic setting.
To activate the remote start, set the function selector
1.
to .
Implement a setting in the app and send it to the ap-
2.
pliance.
Advertisement
Table of Contents
