Smart Card Reader; Removing The Smart Card Reader - Dell P137G Service Manual

Steps
1. Align and place the power-button board on the palm-rest assembly.
2. Replace the two (M2x2.5) screws that secure the power-button board to the palm-rest assembly.
Next steps
1. Install the system board.
NOTE: The system board can be installed with the heat sink attached in order to simplify the procedure and preserve
the thermal bond between the system board and heat sink.
2. Install the assembly inner
3. Install the heat sink -
4. Install the battery.
5. Install the WWAN card.
6. Install the WLAN card.
7. Install the 2280 solid-state drive
8. Install the memory module.
9. Install the base cover.
10. Install the microSD card.
11. Install the SIM card.
12. Exit Service Mode.
13. Follow the procedure in

Smart card reader

Removing the smart card reader

Prerequisites
1. Follow the procedure in
2. Enter Service Mode.
frame.
UMA or discrete based on the system configuration.
or 2230 solid-state
After working inside your
Before working inside your
drive.
computer.
computer.
Removing and installing components 57