Hardware Management And Maintenance; Displaying Hardware Information For The Device; Displaying Operational Statistics For The Device - HP 850 Unified Wired-WLAN Appliance Installation Manual

Table of Contents

Advertisement

Hardware management and maintenance

The CLI and outputs depend on the software version that is running on the device.

Displaying hardware information for the device

Use the display version command to display software and hardware version information about the
device. The output includes the following information: the current software, the hardware version, and the
device operating time. The output depends on the software and hardware version of the device.
<HP>display version
HP Comware Platform Software
Comware Software, Version 5.20.109, ESS 2607P14
Copyright (c) 2010-2013 Hewlett-Packard Development Company, L.P.
HP 850 uptime is 0 week, 0 day, 0 hour, 36 minutes
HP 850 with 1 RMI XLP 432 1400MHz Processor
4096M bytes DDR3
16M bytes Flash Memory
3919M bytes CFCard Memory
Hardware Version is Ver.A
CPLD 1 CPLD Version is 002
Basic Bootrom Version is 1.05
Extend Bootrom Version is 1.05
[Subslot 0]850 Hardware Version is Ver.A

Displaying operational statistics for the device

When you perform routine maintenance or the system fails, you might need to display the operational
information of each feature module to locate failures. Typically, you need to run the display commands
individually. However, you can use the display diagnostic-information command in any view to display
or save the operational statistics of multiple feature modules of the device. This command displays the
output of the display clock, display version, display device, and display current-configuration
commands.
Save the operational statistics for each feature module of the device:
<HP>display diagnostic-information
Save or display diagnostic information (Y=save, N=display)? [Y/N]:y
Please input the file name(*.diag)[cfa0:/default.diag]:
Diagnostic information is outputting to cfa0:/default.diag.
Please wait...
Save successfully.
Execute the more default.diag command in user view, and then press the Page Up and Page Down
keys to view the contents of the file default.diag.
Display the operational statistics for each feature module of the device. (Details not shown.)
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

850 unified wired-wlan taa-compliant appliance

Table of Contents