Enabling The Hourly Time Signal; Turning Off An Alarm Or The Hourly Time Signal; Stopwatch; Measuring Elapsed Time - Casio 3536 Operation Manual

Enabling the Hourly Time
Signal
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled and disabled.
[SIG] is shown on the display while the
●
hourly time signal is turned on.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Hourly time signal
Snooze
Watch Operation Guide 3536
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to scroll through the alarm ([1] to
[4], [SNZ]) and hourly time signal ([SIG])
screens until the one you want to turn off
is displayed.
3.
Press (A) to turn off the displayed alarm or
the hourly time signal.
Each press of (A) toggles between on
●
and off.
Turning off all alarms causes [ALM]
●
(alarm) to disappear from the display.
Turning off the hourly time signal
causes [SIG] (hourly time signal) to
disappear.
Note
If [ALM] (alarm) is still displayed after
●
you turn off an alarm, it means that at
least one of the other alarms is still
turned on. To turn off all of the alarms,
repeat steps 2 and 3 until the [ALM]
(alarm) indicator is no longer
displayed.
Alarm number or hourly time signal

Stopwatch

The stopwatch measures elapsed time in units
of 1/100 seconds up to 59 minutes, 59.99
seconds (60 minutes).
When this maximum limit is exceeded,
elapsed time measurement returns to 0 and
timing continues from there.

Measuring Elapsed Time

1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
1/100 seconds
Minutes, seconds
2.
Use the operations below to measure
elapsed time.
Start
Stop
Resume
Stop
Graphic segments appear and
●
disappear on the display to indicate
measurement of elapsed time.
3.
Press (A) to reset the measurement time
to all zeros.
10