•
Disabling an equipped 3-Wheel-Drive Kit; refer
to
Disabling an Equipped 3-Wheel-Drive Kit (page
27).
•
Battery-reserve capacity; refer to
Battery-Reserve Capacity (page
Note:
Each setting is passcode-protected. You may
need to enter a passcode to edit the settings.
Adjusting the Tap-Off Delay
Navigate to the T
APOFF
tap-off delay. The tap-off delay feature allows the
cutting units to turn off without raising. The delay
setting represents the maximum time for the lift/lower
joystick to remain in the rearward position to activate
this feature.
Refer to the following table for the delay time options
and their corresponding increment numbers:
Tap-Off Delay Options
Increment Number
1
2
3
4
5
6
7
8
9
10
Note:
The factory default setting is 1, which disables
this feature.
Adjusting the Mowing Reel Speed
Navigate to the R
S
EEL
speed while mowing. This setting can be adjusted
when the clip control setting is O
the Clip-Control Feature (page
Refer to the following table for the reel speed options
and their corresponding increment numbers:
Mowing Reel Speed Options
Increment Number
1
2
3
4
5
Setting the
28).
T
option to adjust the
IME
Delay Time (Seconds)
Off
0.050
0.100
0.150
0.200
0.250
0.300
0.350
0.400
0.450
option to adjust the reel
PEED
; refer to
Setting
FF
27).
Reel Speed (RPM)
800
950
1100
1250
1400
Mowing Reel Speed Options (cont'd.)
6
7
8
9
Note:
The factory default setting is 2000 rpm
(increment number 9).
Setting the Cutting-Unit Lower
Speed
Navigate to the L
OWER
that the cutting units lower to the ground for mowing.
You can toggle between 1 (slowest speed) and 9
(quickest speed).
Test the lower speed before you mow. Adjust the
speed as desired.
Note:
The factory default setting is 5.
Adjusting the Backlap Reel Speed
Navigate to the B
ACKLAP
speed while performing a backlap operation.
Refer to the following table for the reel speed options
and their corresponding increment numbers:
Backlap Reel Speed Options
Increment Number
1
2
3
4
5
6
7
8
9
Note:
The factory default setting is 200 rpm
(increment number 1).
Adjusting the Clip-Control Feature
Understanding the Radius-Dependent-Speed
(RDS) System
To achieve a consistent, high quality-of-cut and a
uniform after cut appearance, the machine is equipped
26
1550
1700
1850
2000
S
option to set the speed
PEED
RPM option to adjust the reel
Reel Speed (RPM)
200
240
280
320
360
400
440
480
520