Maintenance; Greasing The Bearings - Toro 30834 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.

Greasing the Bearings

Each cutting deck has two grease fittings per spindle. Either
fitting can be used, which ever is more accessible. If
machine is operated under normal conditions, lubricate
blade spindle bearings (Fig. 6) with No. 2 general purpose
lithium base grease or molybdenum base grease, after every
50 hours of operation. Pump grease into fitting until a small
amount appears at bottom of spindle housing (under deck).
Figure 6
Caution
Each cutting deck has two grease fittings per rear roller If
machine is operated under normal conditions, lubricate rear
roller bearings (Fig. 7) with No. 2 general purpose lithium
base grease or molybdenum base grease, after every 50
hours of operation. The fittings are flush fittings and
require a grease gun nozzle adapter, Toro Part No.
107–1998 which can be obtained from your Authorized
Toro Distributor.
10
Figure 7