Communications Settings; Viewing Connected Devices; Setting Alarms; Navigation Alarms - Garmin ECHOMAP UHD2 7X Owner's Manual

Communications Settings

Viewing Connected Devices

You can view lists of the connected devices on the vessel including which chartplotter a device is connected to
or paired with.
1 Select > Communications.
2 Select a network.
3 Select Device List.
A list of network devices appears. If a device is connected to or paired with a specific chartplotter, the name
of the chartplotter is shown along with the device name.
NOTE: Some devices included in the NMEA 2000
station on the vessel. You can select Related To: to see more information about which chartplotter the
device is connected to.

Setting Alarms

The Beeper setting must be turned on to make alarms audible
set audible alarms could lead to injury or property damage.

Navigation Alarms

Select > Alarms > Navigation.
Arrival: Sets an alarm to sound when you are within a specified distance or time from a turn or a destination.
Anchor Drag: Sets an alarm to sound when you exceed a specified drift distance while anchored.
The anchor drag alarm is a tool for situational awareness only and may not prevent groundings or collisions in
all circumstances. You are responsible for the safe and prudent operation of your vessel, for remaining aware of
your surroundings, and for using safe judgment on the water at all times.
Off Course: Sets an alarm to sound when you are off course by a specified distance.
Boundary Alarms: Disables and enables all boundary alarms.
Setting the Anchor Drag Alarm
You can set an alarm to sound if you have moved outside an allowable radius you set when configuring the
alarm.
The anchor drag alarm is a tool for situational awareness only, and may not prevent grounding or collisions in
all circumstances. You are responsible for the safe and prudent operation of your vessel, for remaining aware
of your surroundings, and for using safe judgement on the water at all times. Failure to heed this warning could
result in property damage, serious personal injury, or death.
The Beeper setting must be turned on to make alarms audible
set audible alarms could lead to injury or property damage.
1 Select > Alarms > Navigation > Anchor Drag.
2 Select Alarm to turn on the alarm.
3 Select Set Radius, and select a distance on the chart.
4 Select BACK.
58
® device list may be connected to a chartplotter at another
CAUTION
(Sounds and Display Settings,
WARNING
WARNING
CAUTION
(Sounds and Display Settings,
page 53). Failure to
page 53). Failure to
Device Configuration