Table of Contents
Advertisement
To
ESPEED,
run
prompt and
You see the following messages:
These messages tell you the switches you should use to set the
speed to high, low, or automatic. At the MS-DOS prompt, type
the ESPEED command again and include the appropriate
switch, such as the following:
(This command sets the processor speed to change to low speed
automatically when the computer accesses a diskette.)
If you include the switch when you type the initial ESPEED
command, the program changes the speed without displaying
the command options.
The processor speed you set remains in effect until you change
1-32
Using Your
the following at the MS-DOS command
Computer
Advertisement
Table of Contents
