Table of Contents
Advertisement
If you are leaving the drive bay empty, replace the metal
3.
drive bay cover and two retaining screws, as shown below.
If you are replacing the drive you removed with another
4.
drive, remove the guiderails and screws from the drive and
use them to install the other drive as described in
"Installing a Drive in a Horizontal Bay" on page 3-17.
5. Wrap the drive in its original packing materials and store it
in a safe place.
6. If you removed your computer's only hard disk drive,
disconnect the hard disk drive ribbon cable from the system
board and store it as well.
If you removed one hard disk drive and are leaving another
one in the computer, you need to set the jumpers on the
remaining drive to indicate that you now have only one
hard disk drive. See the documentation that came with the
drive for the correct jumper settings.
installing and Removing Drives
3-31
Advertisement
Table of Contents
