Removing A Hard Disk Drive From The Vertical Position - Epson NX Service Manual

Removing a Hard Disk Drive From the Vertical Position

Follow these steps to remove an IDE hard disk drive in the vertical position:
1 Remove the computer's cover as described on page 3-2.
2 Remove the HDD mounting bracket screw located on top of the drive bay as shown in
Figure 3- 12.
Slide the drive toward the back of the computer and gently lift out the hard drive and
3
its mounting bracket (the mounting bracket has tabs inserted in slots on the bottom of
the system chassis).
4 Remove the four screws located on the back of the hard drive mounting bracket to
remove the hard drive. Keep the screws so that you can use them to install a drive
later.
5
Replace the hard drive mounting bracket onto the drive bay and secure both in place
with the screw removed in step 2 above.
6 Replace the cover (see page 3-4).
7
Reconfigure the system with the SETUP utility before using the computer.
Figure 3-12 Removing/Installing a Vertical HDD
Removing and Replacing Subassemblies