Replacing The System Board; Removing The Front Bezel - Epson NX Service Manual

Replacing the System Board

Follow these steps to replace the system board:
1 From the left side of the chassis, insert the system board into the chassis at a slight
angle.
Slide the far edge of the system board under the drive bay.
2
3 Lower the board into the chassis and position the six screw holes over the mounting
holes in the chassis.
4 Secure the board with the six retaining screws (see Figure 3-17).
5 Reinstall the option card riser board (see page 3-8) and replace any option cards (see
page 3-7).
6 Reconnect all cables and replace the cover.

Removing the Front Bezel

Follow these steps to remove the front bezel:
1 Remove the cover (see page 3-2).
2 Remove the two retaining screws located on the back side of the bezel as shown in
Figure 3-18.
Figure 3-18 Removing/Replacing the Front Bezel
3 Set the cover upside down on a smooth flat surface and locating the front bezel
locking tabs gently press down on the tabs while pulling the bezel away from the
cover.
Removing and Replacing Subassemblies
3-23