Epson NX Service Manual page 67

6 If you are installing a diskette or tape drive in the lower drive bay, locate the diskette
drive cable; one end is connected to the upper diskette drive and the other end is
connected to the FDD interface connector (CN7). Use the middle conneCtor to connect
the second drive. If installing a hard disk drive in the lower drive bay, locate the HDD
cable; one end may be connected to an already installed hard disk drive located in the
vertical position outside of the main drive bays and the other end is connected to the
HDD interface connector (CN6). Use the middle connector to connect the second
drive if one end is already connected to a hard drive or leave the middle connector
free and use the end connector if no other HDD drive is present.
Ensure that the connector is aligned properly and fits properly onto the drive interface.
7
See Figure 3- 11.
Locate one of the power supply cable connectors that lead from the power supply
8
behind the horizontal bays. The cables are labeled PA, PB, PC, and PD; plug the
appropriate size connector that is free to the power supply socket in the drive (see
Figure 3- 11).
9
Replace the cover (see page 3-4).
10
Reconfigure the system with the SETUP utility before using the computer.
Figure 3-11 Attaching Drive Cables
cable