Installing And Removing An Ide Hard Disk Drive - Epson Powerspan User Manual

4. If necessary, remove the slide rails and grounding clips from
the drive. Set them and the screws aside for safekeeping.
5. Replace the front panel slot cover, if necessary.
6. Replace the front panel as described in Chapter 5.
Note
Once you have reassembled the computer, you need to run
the SETUP program or the EISA Configuration utility to
inform the system that a diskette drive or other device is
removed. For information, see Chapters 2 and 3.

Installing and Removing an IDE Hard Disk Drive

Your computer supports up to two IDE hard disk drives, which
can be installed in the upper internal drive bays. Before you
install a new IDE drive, be sure to check the drive's
documentation for the correct jumper settings for the drive. If
you are installing your second drive, you may also need to
change the jumper settings on the drive installed in your
system to indicate which drive is the primary (master) drive
and which is the secondary (slave) drive.
Now follow the steps in the next section to remove the IDE
drive bay assembly.
Installing and Removing Disk Drives
7-9