Table of Contents
Advertisement
Installation & Setup (cont.)
Shelf Installation
Procedure
1. Determine the desired height for the shelf/pan slide.
2. Align the shelf/pan slide tabs with the notches in the front and
rear pilasters at the desired height. See fig. 1.
3. Slide the tabs into the notches and verify the unit is level.
See fig. 2.
4. Gently push down to lock the shelf/pan slide into position.
See fig. 3.
5. Repeat steps 1-3 for the remaining shelf/pan slides. Be sure to
install the slides in pairs at the same height. See fig. 4.
6. Slide the wire shelves into the top slide channels. See fig. 5.
The bottom slide channels will accommodate a
NOTICE ›
product pan. See fig. 6. Product pans are not included.
Shelf Adjustment
Shelving is adjustable for customer application. This cabinet meets
the IEC Shelf Weight Capacity of 173lb (78.47kg).
Fig. 1. Line the tabs up with the notches.
Fig. 2. Position the shelf/pan slide.
Fig. 3. Push down to make sure the slide is fully seated.
Page 16 of 32
TGN Refrigerators & Freezers
Fig. 4. Installed shelf/pan slide.
Fig. 5. Position the wire shelving.
A
B
Fig. 6. If desired, slide product pans into the channels. Product pans not included.
07/25/2023
P#857039
TEC_TM_076 | REV. C | EN
truemfg.com
Advertisement
Table of Contents
