True TGN-2R-2S-HC Installation Manual page 12

Installation & Setup (cont.)
Procedure
1. Remove the outer packaging (cardboard and bubble wrap
or Styrofoam corner and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with the
freight carrier if there is damage.
2. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the appliance. See fig. 2.
Move the appliance as close as possible to the
NOTICE ›
final location before removing the wooden skid. Some models
may require removing the front and/or rear grill/cover to access
the shipping bolts.
3. If leveling legs or castors will not be used, remove the
appliance from the wood skid and set the skid aside.
DO NOT lift the appliance by the counter tops,
NOTICE ›
doors, drawers, or grills.
If leveling legs or castors will be used, rotate the appliance on
the skid (see fig. 3) and see the installation instructions on
page 13.
Fig. 2. Shipping bolt locations.
Page 12 of 32
TGN Refrigerators & Freezers
Fig. 1. Remove exterior packaging.
Fig. 3. When lifting unit, do not use countertops, doors/drawers, or grills as a
lifting point.
07/25/2023 P#857039 TEC_TM_076 | REV. C | EN
truemfg.com