Level The Appliance; Seal The Appliance To The Floor; Shelf Installation - True CVM-11 Series Installation Manual

Installation & Setup (cont.)

Level the Appliance

Tipping hazard! ALWAYS
screws, castors, or leveling legs fully contact the floor
after leveling the appliance.
Proper leveling of your TRUE appliance is critical to operating
success (for non-mobile appliances). Leveling impacts effective
condensate removal and door operation.
See "Leveling Screw, Leg or Castor Installation" (pg. 14) for level
adjustment and shimming information.
Level the unit front-to-back and side-to-side.
Fig. 1. Measure the level along the perimeter of the interior floor.

Seal the Appliance to the Floor

USER ACTION!
Asphalt floors are susceptible to chemicals. TRUE
recommends installing a layer of tape between the
asphalt and the sealant to protect the floor.
If sealing the appliance to the floor, be sure to use NSF-approved
sealants. See model-specific installation manuals for more details.
TEC_TM_169 | REV. B | ALL
WARNING!
verify center leveling
QUICK START MANUAL

Shelf Installation

Overloading, incorrectly
installing, or improperly
loading shelves
shelf failure and negatively
affect appliance operation,
resulting in appliance damage,
product damage, or personal injury.
DO NOT use pliers or any crimping tools
installing shelf clips. Altering shelf clips in any way can
lead to shelving instability.
Shelf Adjustment
Shelving is adjustable to meet your application requirements. This
appliance meets the IEC Shelf Weight Capacity of 47lb/ft2 (230kg/
m2) unless otherwise stated in the model-specific installation
manual.
Installation Tips
• Install all the shelf clips before installing any shelves.
• Start at the bottom shelf and work your way up.
• Always lay the back of each shelf down on the rear clips
before the front.
08/3/2023
WARNING!
can cause
truemfg.com
when
Page 15 of 240