Engine Consumable Specifications; Engine Fuel Specifications; Engine Oil Specifications - Atlas Copco PTS 800 T3 Cud Instruction Manual

6.5 Engine consumable
specifications

6.5.1 Engine fuel specifications

For fuel specifications, please contact your Atlas
Copco Customer Center.

6.5.2 Engine oil specifications

It is strongly recommended to use
!
Atlas Copco branded lubrication
oils for both compressor and engine.
High-quality, mineral, hydraulic or synthesized
hydrocarbon oil with rust and oxidation inhibitors,
anti-foam and anti-wear properties is recommended.
The viscosity grade should correspond to the ambient
temperature and ISO 3448, as follows.
Ambient temperature
Type of lubricant
range
PAROIL E Mission
between -10°C and 50°C
between -25°C and 50°C
Never mix synthetic with mineral
!
oil.
Specifications PAROIL
PAROIL from Atlas Copco is the ONLY oil tested
and approved for use in all engines built into Atlas
Copco compressors and generators.
Extensive laboratory and field endurance tests on
Atlas Copco equipment have proven PAROIL to
match all lubrication demands in varied conditions. It
meets stringent quality control specifications to
Green
ensure your equipment will run smoothly and
reliably.
PAROIL E Xtra
The quality lubricant additives in PAROIL allow for
extended oil change intervals without any loss in
performance or longevity.
After a complete change over to
synthetic oil (or the other way
around), you will need to do an
extra rinse:
After doing the complete change
procedure to synthetic oil, run the
unit for a few minutes to allow
proper and complete circulation of
the synthetic oil.
Then drain the synthetic oil again
and fill again with new synthetic oil.
To set correct oil levels, follow the
normal instructions.
- 72 -
PAROIL provides wear protection under extreme
conditions. Powerful oxidation resistance, high
chemical stability and rust- inhibiting additives help
reduce corrosion, even within engines left idle for
extended periods.
PAROIL contains high quality anti-oxidants to
control deposits, sludge and contaminants that tend to
build up under very high temperatures.
PAROIL's detergent additives keep sludge forming
particles in a fine suspension instead of allowing them
to clog your filter and accumulate in the valve/rocker
cover area.
PAROIL releases excess heat efficiently, whilst
maintaining excellent bore-polish protection to limit
oil consumption.
PAROIL has an excellent Total Base Number (TBN)
retention and more alkalinity to control acid
formation.
PAROIL prevents Soot build-up.
PAROIL is optimized for the latest low emission
EURO -3 & -2, EPA TIER II, III & IV engines
running on low sulphur diesel for lower oil and fuel
consumption.
PAROIL E Xtra and PAROIL E Mission Green are
low SAPS oil. These oils are to be used in Stage IIIB/
Tier 4 Interim engines in order to provide the full
performance and life of the engine and aftertreatment
systems.