Table of Contents
Advertisement
IMPORTANT:
Before turning on the supply valve for the first
time, follow the steps below to clear sand, debris and rust
from the system:
Make sure water supply is off. Remove valve END by
rotating it 1/8 turn counterclockwise.
While holding a container over the uncapped VALVE to
prevent splashing, turn water supply on and off a few times.
Leave water supply off.
Replace END by engaging lugs and rotating 1/8 turn
clockwise.
Make certain the top is turned to the locked
position. Valve may not turn on if top is not fully in the
locked position.
Turn on water supply. Check that water level is at the marked
water line.
Install the toilet seat according to the
seat manufacturer's installation
instructions.
Connect the push button and flush
valve.
FILL VALVE ADJUSTMENT
Fill float with ballast
Adjust the cam clockwise or counter-
clockwise until the water level is at the
marked water line.
Test flush the toilet.
Check all connections for leakage for
several days.
Set the tank cover in place on the tank.
CONTINUOUS CLEAN
For K-23191T-ITNS/K-23192T-ITNS
1. Install and connect the CONTINUOUS CLEAN.
Refer to the illustration on
the right for the positions
of refill tube, fill valve,
flush valve and bowl
cleaner.
1402301-T01-B
Fig.#17
17
Fig.#18
18
(
K-23191T-ITNS/K-23192T-ITNS
1.
Refer to the illustration on
the right for structure of
flush valve.
.
Fig.#19
19
-6-
1/8
1/8
)
(
)
Place to connect the water refill tube
Advertisement
Table of Contents
