Table of Contents
Advertisement
Firmly press the toilet gasket onto the
toilet outlet of plastic trap.
NOTE 1:
Wax ring type toilet gasket
should not be installed at temperatures
o
less than 21 C.
NOTE 2:
If you are using a toilet
gasket with an integral plastic sleeve,
make sure the gasket is positioned
with the sleeve facing away from the
toilet.
Install plastic to ground and mounted
with 3 set of bolts
(not supplied)
NOTE: Must use the toilet installation
gasket ring (not supplied) to seal the
area where the waste pipe contacts
the construction section to avoid
leakage.
Thread the supply hose onto the fill valve shank.
Slide nut of inlet cover onto the supply hose, with flared end
last and run hose through toilet wall.
Take hose guide apart and slide onto
the supply hose, with the flared end
last. Slide the two inserts into the
flared end of the hose guide. Insert
into toilet wall and tighten nut.
1402301-T01-B
Plastic Trap Outlet
firmly.
Fig.#9
9
Hose Guide
Toilet Gasket
Fig.#7
7
Fig.#8
8
Fig.#11
11
-4-
1
o
21
C
2
3
)
)
Fig.#10
10
(
(
Advertisement
Table of Contents
